Siemens SINUMERIK 828D Commissioning Manual

3. The system then requests a warm start. Confirm with "Yes". This operation can take several
minutes.
4. After the warm start you will receive an overview of the topology. Confirm with "OK" to
continue the commissioning.
Note
Establishing a defined initial state
If the automatic device
configuration does not start then it has already been implemented: To
establish a defined state or to start once more, please load "Factory settings". After that, a
defined output state is present again.
Commissioning the drive
5.1 Commissioning the drive
CNC commissioning
96 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash