Siemens SINUMERIK 828D Commissioning Manual

Procedure:
1. Select "Change" to configure the spindle:
2. The characteristic data of the automatic device configuration of the drive object (DO3) is
displayed:
Optionally, you can activate the function modules, which in some cases require a license.
This way, further parameters become active, which are required for commissioning the
relevant function module.
Commissioning the drive
5.1 Commissioning the drive
CNC commissioning
100 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash