Siemens SINUMERIK 828D Commissioning Manual

DB1800 Acknowledgment block [r/w]
DBB5002 Acknowl‐
edgment
block 24
Acknowl‐
edgment
block 23
Acknowl‐
edgment
block 22
Acknowl‐
edgment
block 21
Acknowl‐
edgment
block 20
Acknowl‐
edgment
block 19
Acknowl‐
edgment
block 18
Acknowl‐
edgment
block 17
DBB5003 Acknowl‐
edgment
block 32
Acknowl‐
edgment
block 31
Acknowl‐
edgment
block 30
Acknowl‐
edgment
block 29
Acknowl‐
edgment
block 28
Acknowl‐
edgment
block 27
Acknowl‐
edgment
block 26
Acknowl‐
edgment
block 25
Acknowledgment block n: The acknowledgment blocking bit assigned to task n.
If the bit is set via SINUMERIK Operate or from the PLC user program, the task is not acknowledged even when the
acknowledgment bit is set.
TRUE: Acknowledgment of the task blocked
FALSE: Acknowledgment of the task permitted
In this way, it is possible, for example, to incorporate a sensor in the PLC user program, which signals that the maintenance
task has been performed, and, if required, block the acknowledgment.
Service Planner
7.1 Interfaces in the PLC user program
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 229

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash