Siemens SINUMERIK 828D Commissioning Manual

3. To call the "Startup menu", press the following keys in succession:
Menu back key, HSK2 (horizontal softkey 2), VSK2 (vertical softkey 2)
Note
PPU with touch operation
To
call
the
Startup
menu during startup, there is an additional shortcut for all PPUs: "8" →
"2" → "8"
4. The "Startup menu" is displayed, "Normal startup" is the default setting.
Operating modes for startup
Selection Function
Normal startup The system carries out a normal startup.
Reload saved user data The system loads the stored user data ("Save data" softkey) from
the system CompactFlash card.
Install software update/backup An update is installed on the system CompactFlash card from the
user CompactFlash card or USB FlashDrive.
Scope of delivery and requirements
1.4 Starting up the control
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 17

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash