Siemens SINUMERIK 828D

4.4.3 Ethernet network diagnostics.................................................................................................44
4.4.3.1 Diagnostics of the network and DHCP server........................................................................44
4.4.3.2 Accessible nodes...................................................................................................................45
5 Customizing the "Machine" operating area................................................................................................49
5.1 Setting the font size of the actual value display.....................................................................49
5.2 Inserting a user-specific logo.................................................................................................49
5.3 Configuring the display of the G-code groups........................................................................50
5.4 Configuring the channel operational message.......................................................................51
5.5 Deactivating program test......................................................................................................55
5.6 Activating the "Teach In" function..........................................................................................55
5.7 Block search...........................................................................................................................57
5.7.1 Activating block search mode................................................................................................57
5.7.2 Accelerated block search for execution from external...........................................................58
5.8 Manual machine.....................................................................................................................59
5.9 Multi-channel support.............................................................................................................61
5.10 Configuring the offset display.................................................................................................63
5.11 Activate machining time recording.........................................................................................63
6 Simulation and simultaneous recording......................................................................................................65
6.1 Simulation overview...............................................................................................................65
6.2 Setting the technology for simulation.....................................................................................67
6.3 Simultaneous recording overview..........................................................................................69
6.4 Clamping a blank...................................................................................................................70
7 Configuring cycles......................................................................................................................................75
7.1 Activating turning/milling/drilling/grinding technologies..........................................................75
7.2 Technology cycles for drilling.................................................................................................79
7.3 Manufacturer cycles...............................................................................................................81
7.3.1 Manufacturer cycles...............................................................................................................81
7.3.2 PROG_EVENT.SPF standard cycle.......................................................................................82
7.3.3 Manufacturer cycle for tool change CUST_T and CUST_M6.................................................83
7.3.4 CUST_TECHCYC.SPF manufacturer cycle...........................................................................84
7.3.5 CUST_MULTICHAN user cycle.............................................................................................87
7.3.6 Commissioning multi-channel machines with programSYNC................................................87
7.4 Milling.....................................................................................................................................95
7.4.1 General..................................................................................................................................95
7.4.2 Technology cycles for milling.................................................................................................95
7.4.3 Setting-up ShopMill cycles for milling.....................................................................................96
7.4.4 Cylinder surface transformation (TRACYL)............................................................................99
7.4.5 Example: Milling machine with general axis configuration and TRACYL.............................100
7.4.6 ShopMill cycles for multiple clamping..................................................................................103
7.5 Turning.................................................................................................................................105
7.5.1 General................................................................................................................................105
Table of contents
SINUMERIK Operate
4 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3