7.5.2 Setting up cycles for turning.................................................................................................105
7.5.3 Setting-up ShopTurn cycles for turning................................................................................109
7.5.4 Setting up a counterspindle..................................................................................................111
7.5.5 Setting up the counterspindle under ShopTurn....................................................................113
7.5.6 Technology cycles for turning..............................................................................................115
7.5.7 Single-channel and two-channel sensors...........................................................................118
7.5.8 Example: Two-channel turning machine with general axis configuration.............................120
7.5.9 Cylinder surface transformation (TRACYL)..........................................................................122
7.5.10 End face machining (TRANSMIT)........................................................................................125
7.5.11 Inclined Y axis (TRAANG)....................................................................................................128
7.5.12 X zero point not at the rotation center..................................................................................131
7.5.13 Spindle speed limitation for current program.......................................................................132
7.6 grinding................................................................................................................................133
7.7 Swiveling..............................................................................................................................135
7.7.1 Technology cycles for swiveling...........................................................................................135
7.7.2 CYCLE800 checklist for the identification of the machine kinematics..................................141
7.7.3 Commissioning swivel data (kinematics chain)....................................................................142
7.7.4 Examples of machine kinematics for the commissioning of the Swivel function..................150
7.7.5 Manufacturer cycle CUST_800.SPF....................................................................................159
7.7.6 CYCLE996 measure workpiece kinematics.........................................................................165
7.8 High Speed Cutting (HSC)...................................................................................................167
7.8.1 High speed settings: Configuring CYCLE832......................................................................167
7.8.2 Manufacturer cycle CUST_832.SPF....................................................................................168
7.8.3 Top Surface: CYCLE832 extension.....................................................................................169
7.9 Measuring cycles and measurement functions....................................................................170
7.9.1 Measuring cycles and measurement functions, general......................................................170
7.9.2 Manufacturer and user cycle CUST_MEACYC.SPF............................................................173
7.9.3 Measuring in the JOG mode................................................................................................176
7.9.3.1 Measuring workpieces at the milling machines....................................................................178
7.9.3.2 Measuring tools at the milling machines..............................................................................180
7.9.3.3 Measuring tools at the turning machines.............................................................................185
7.9.3.4 Measuring without electronic probe in JOG.........................................................................186
7.9.4 Measuring in the AUTOMATIC mode..................................................................................186
7.9.4.1 Measuring workpieces, general ..........................................................................................188
7.9.4.2 Measuring workpieces at the milling machines....................................................................191
7.9.4.3 Measuring tools at the milling machines..............................................................................192
7.9.4.4 Measuring workpieces at the turning machines...................................................................198
7.9.4.5 Measuring tools at the turning machines.............................................................................199
7.10 Compare cycles version.......................................................................................................200
7.10.1 Display cycles version..........................................................................................................200
7.10.2 Specify cycles version..........................................................................................................201
7.11 Cycle protection (option)......................................................................................................203
7.11.1 Overview, cycle protection...................................................................................................203
8 Spindle function........................................................................................................................................205
8.1 Spindle control.....................................................................................................................205
8.2 Analog spindle......................................................................................................................207
8.3 Leadscrew error compensation............................................................................................207
Table of contents
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 5
To Next Page
Loading...
