8.4 Spindle diagnostics..............................................................................................................208
8.4.1 Spindle diagnostics..............................................................................................................208
8.4.2 Temperatures.......................................................................................................................210
8.4.3 Motor temperature sensor....................................................................................................212
8.4.4 Additional temperature sensor.............................................................................................213
8.4.5 Temperature histograms......................................................................................................213
8.4.6 Speed/torque........................................................................................................................214
8.4.7 Clamping system..................................................................................................................214
8.4.8 Clamping system: Speed limits............................................................................................216
8.4.9 Clamping system: Diagnostic statistics................................................................................217
8.4.10 Clamping system: Clamping time statistics..........................................................................218
8.4.11 Fetching the logistics data....................................................................................................219
9 Tool management.....................................................................................................................................221
9.1 Machine data for tool management......................................................................................221
9.1.1 Settings with/without magazine management......................................................................221
9.1.2 Configuring the access levels of the tool management........................................................223
9.1.3 Additional settings................................................................................................................224
9.2 Configuring the user interface..............................................................................................228
9.2.1 General settings...................................................................................................................230
9.2.2 Configure the tool lists..........................................................................................................236
9.2.2.1 Tool parameter identifiers....................................................................................................240
9.2.2.2 Cutting parameter identifiers................................................................................................242
9.2.2.3 Monitoring parameter identifiers...........................................................................................244
9.2.2.4 Grinding parameter identifiers..............................................................................................245
9.2.2.5 Magazine location parameter identifiers..............................................................................246
9.2.2.6 Magazine location adapter parameter identifiers.................................................................247
9.2.2.7 Multitool parameter identifiers..............................................................................................247
9.2.2.8 Multitool location parameter identifiers.................................................................................248
9.2.3 Configuring list parameters..................................................................................................249
9.2.4 List of tool types...................................................................................................................253
9.2.5 Configure tool types.............................................................................................................255
9.2.6 Configuring the "Additional Data" window............................................................................257
9.2.7 Configure the "New tool - favorites" window........................................................................259
9.2.8 Configuring the "New Tool" window.....................................................................................259
9.2.9 Configuring the "New Multitool" window...............................................................................260
9.2.10 Configuring the "New Tool from Code Carrier" window.......................................................261
9.2.11 Configuring the "New Tool from File" window......................................................................261
9.2.12 Configuring default values for new tools..............................................................................262
9.2.13 Configuring the "Details" window.........................................................................................266
9.2.14 Assignment of TO units and toolholders to channels...........................................................266
9.2.15 Assigning a name for magazines and magazine locations..................................................269
9.2.16 Configuring the "Assign Tooltips for Multitool Locations" window........................................271
9.2.17 Assigning a name for magazine location types....................................................................271
9.2.18 Assignment of magazines and magazine locations to channels..........................................273
9.2.19 Assignment between magazines and magazine locations and coordinate systems............274
9.2.20 Disabling the softkey depending on filters............................................................................276
9.2.21 Configuring the "Load Station Selection" window................................................................277
9.2.22 Coolant and tool-specific functions......................................................................................277
9.2.23 Reason for the tool change when reactivating.....................................................................281
9.2.24 Configure the code carrier connection.................................................................................284
Table of contents
SINUMERIK Operate
6 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
