56 = condwait.png ; Axis replacement: Axis is oscillating axis
57 = condwait.png ; Axis replacement: Axis is Jog axis
58 = condwait.png ; Axis replacement: Command axis
58 = condwait.png ; Axis replacement: Axis is OEM axis
60 = condwait.png ; Coupled following axis
61 = condwait.png ; Coupled-motion following axis
62 = condwait.png ; Coupled slave axis
63 = condstop.png ; Stop at cycle end M0
64 = condstop.png ; Stop at cycle end M1
65 = condwait.png ; Wait: Axis is at fixed stop
66 = condwait.png ; Master-slave switchover active
67 = condwait.png ; Axis replacement: Axis is single axis
68 = condstop.png ; Stop: Target reached after block search
69 = condwait.png ; Synchronism: Synchronous spindle
70 = condwait.png ; Deactivation position synch. spindle
71 = condwait.png ; Waiting for transformer axis enable
72 = condstop.png ; Waiting because of possible collision
73 = condstop.png ; Jog: Position reached
74 = condstop.png ; Jog: Direction blocked
75 = condwait.png ; Brake request
76 = condwait.png ; Wait: G4 still: U
77 = condstop.png ; Axial feed disable from PLC
78 = condstop.png ; Waiting for axial feed enable
79 = condwait.png ; Axial feed disable from SYNACT
80 = condwait.png ; Waiting for master spindle speed
81 = condwait.png ; Waiting for parameter set change
82 = condwait.png ; Waiting for end of motion before
transformation change
83 = condwait.png
84 = condwait.png
85 = condwait.png
[CondDelayTime]
Default delay time = 1000
1 = 0 ; No NC ready
2 = 0 ; No mode group ready
3 = 0 ; EMERGENCY STOP active
4 = 0 ; Alarm with stop active
5 = 0 ; M0/M1 active
6 = 0 ; Block in SBL mode terminated
7 = 0 ; NC stop active
8 = 0 ; Read-in enable missing
Customizing the "Machine" operating area
5.4 Configuring the channel operational message
SINUMERIK Operate
54 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
