Siemens SINUMERIK 828D

14 = condwait.png ; Waiting for positioning axis
15 = condwait.png ; Waiting for spindle
15 = condwait.png ; Waiting for other channel
17 = condstop.png ; Waiting for feedrate override
18 = condstop.png ; Error in NC block
19 = condstop.png ; Waiting for external NC blocks
20 = condwait.png ; Waiting for synchronized action
21 = condwait.png ; Block search active
22 = condstop.png ; Spindle enable missing
23 = condstop.png ; Axis feedrate override
24 = condwait.png ; Waiting for tool change acknowledgment
25 = condwait.png ; Gear step change
26 = condwait.png ; Waiting for position control
27 = condwait.png ; Waiting for thread cut
28 = condwait.png ; Reserved
29 = condwait.png ; Waiting for punching
30 = condwait.png ; Waiting for safe operation
31 = condwait.png ; No channel ready
32 = condstop.png ; Oscillation active
33 = condwait.png ; Axis replacement active
34 = condwait.png ; Axis container rotation
35 = condwait.png ; AXCT: Following axis active
36 = condwait.png ; AXCT: Leading axis active
37 = condwait.png ; AXCT: Follow-up active
38 = condwait.png ; AXCT: Internal status change
39 = condwait.png ; AXCT: Axis/spindle disable
40 = condwait.png ; AXCT: Corr. motion active
41 = condwait.png ; AXCT: Axis replacement active
42 = condwait.png ; AXCT: Axis interpolator active
43 = condwait.png ; Waiting for compile cycle
44 = condwait.png ; Access to system variable
45 = condstop.png ; Search target found
46 = condwait.png ; Rapid retraction started
47 = condwait.png ; AXCT: Wait for spindle stop
48 = condwait.png ; Machine data match
49 = condwait.png ; Axis replacement: Axis coupled
50 = condwait.png ; Axis replacement: Liftfast active
51 = condwait.png ; Axis replacement: New config active
52 = condwait.png ; Axis replacement: AXCTSW active
53 = condwait.png ; Axis replacement: Waitp active
54 = condwait.png ; Axis in another channel
55 = condwait.png ; Axis replacement: Axis is PLC axis
Customizing the "Machine" operating area
5.4 Configuring the channel operational message
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 53