Siemens SINUMERIK 828D

<!-- **** Display for all multitool location types *** -->
<Item value="MultiToolPlaceSpec" type="QString" />
</TOOLTYPE_9997>
</COLUMN11>
</SlTmToolmagazinForm>
</LISTCONFIGURATION>
Variant 2
The new columns are inserted in the standard configuration between the "Magazine location
locked" and "Oversized tool" columns.
<LISTCONFIGURATION>
<!-- **** Magazine list *** -->
<SlTmToolmagazinForm>
<!-- **** Insert column *** -->
<INSERT_COLUMN>
<!-- **** Column 7 *** -->
<COLUMN7>
<!-- **** For all tool types *** -->
<TOOLTYPE_ALL>
<!-- **** Display magazine location type *** -->
<Item value="MagPlaceType" type="QString" />
</TOOLTYPE_ALL>
</COLUMN7>
<!-- **** Column 8 *** -->
<COLUMN8>
<!-- **** For all tool types *** -->
<TOOLTYPE_ALL>
<!-- **** Display tool location type *** -->
<Item value="ToolPlaceSpec" type="QString" />
</TOOLTYPE_ALL>
<!-- **** For all multitools *** -->
<TOOLTYPE_9997>
<!-- **** Display for all multitool location types *** -->
<Item value="MultiToolPlaceSpec" type="QString" />
</TOOLTYPE_9997>
</COLUMN8>
</INSERT_COLUMN>
</SlTmToolmagazinForm>
</LISTCONFIGURATION>
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
238 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3