Siemens SINUMERIK 828D

<CUTTEDGEPOS_3>
<Default value="93.0" type="double" />
</CUTTEDGEPOS_3>
<CUTTEDGEPOS_4>
<Default value="93.0" type="double" />
</CUTTEDGEPOS_4>
<CUTTEDGEPOS_5>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_5>
<CUTTEDGEPOS_6>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_6>
<CUTTEDGEPOS_7>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_7>
<CUTTEDGEPOS_8>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_8>
</HolderAngle>
</TOOLTYPE_500>
<!-- Initialize coolant 2 of the plunge cutter to switched on -->
<TOOLTYPE_520>
<Coolant2>
<Default value="true" type="bool" />
</Coolant2>
</TOOLTYPE_520>
</NEWTOOLDEFAULTVALUECONFIGURATION>
Default values when creating new tools
System variables Default value
Tool size
Size on left $TC_TP3 1
Size on right $TC_TP4 1
Size above $TC_TP5 1
Size below $TC_TP6 1
Magazine location type of the tool
Created outside of the magazine $TC_TP7 1
Created in a magazine location $TC_TP7 Location type of the magazine location
Tool status
released $TC_TP8 2
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 263