<!— Reading of value r0002 on NX1 ->
<OP> r0002_content = "drive/cu/r0002[CU2]" </OP>
<!— Reading of value p107[0] on the CU ->
<OP> p107_content = "drive/cu/p107[0]" </OP>
<PRINT text="%d"> p107_content </PRINT>
<!— Reading of value p107[0] on the CU ->
<OP> p107_content = "drive/cu/p107[0, CU1]" </OP>
<PRINT text="%d"> p107_content </PRINT>
<!— Reading of value p107[0] on the NX1 ->
<OP> p107_content = "drive/cu/p107[0, CU2]" </OP>
<PRINT text="%d"> p107_content </PRINT>
Addressing the drive objects:
To address individual objects, the desired object should be entered in square brackets after
the parameter.
Note
The drive object number differs from the numbering used in the drive dialog, since the CU
components, ALM, and all connected hubs are integrated with the continuous numbering.
The DO number can be established as follows:
● All connected drive objects are listed in field p978 of the relevant CU corresponding to their
slot number.
● It is a question of establishing the field index for the desired slot and adding one to this
number. This value is the DO index needed for addressing purposes.
Generating user dialogs
1.8 Addressing components
Easy XML
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 77
To Next Page
Loading...
Need help?
General
