Siemens SINUMERIK 828D

The definition of a softkey menu (softkey menu definition block) is basically structured as
follows:
Definition block Comment Section reference
//S... ;Start identifier of softkey menu
HSx=... ;Define softkeys
PRESS(HSx)
LM...
END_PRESS
;Method start identifier
;Actions
;Method end identifier
See Section "Methods"
//END ;End identifier of softkey menu
Description
Properties are assigned to softkeys during definition of the softkey menu.
Programming
Syntax: //S
(Identifier)
...
//END
;Start identifier of softkey menu
;End identifier of softkey menu
See also Section Extended configuration syntax (Page 36).
Description: Defines the softkey menu
Parameter: Identifier Name of the softkey menu
Text or image file name
Syntax: SK =
(Text[, Access level][, Status][, Alignment of the softkey image][, Text
alignment in relation to the softkey image])
Description: Define softkey
Parameter: SK Softkey, e.g. HS1 to HS8, VS1 to VS8
Dialogs
4.2 Defining softkey menus
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 51