Silicon Graphics O2+ - Figure 2-41 Returning the Lever to Its Starting Position

Installing an Option Board
007-4486-001 61
1. Push the lever to return it to its starting position (Figure 2-41).
Figure 2-41 Returning the Lever to Its Starting Position
2. Reinstall the PCI tray in the system module (Figure 2-42), as follows:
• Engage the hinge on the PCI tray in the slot on the system module.
• Lower the tray as you push toward the back of the module.
• Align the gold-colored PCI edge connector with the slot on the system board.