Spectra T950 - Page 376

Chapter 12 — Library Troubleshooting Discovering and Setting the BlueScale Vision Camera IP Address
November 2016 User Guide—Spectra T950 Library
376
8. OntheIPAddressSettingsscreen,selectFixed IP AddressorDynamic IP
Address.Clicktheforwardarrow.
IfyouselectFixed IP AddresstheTCP/IPSettingsscreendisplays.Ifyou
selectedDHCP,skiptoStep9onpage377.
SetthedesiredIP,subnetmask,andgatewayaddressesasrequiredfor
yournetworkandenterDNS(DomainNameServer)information.The
factorydefaultsare:
Notes:  ThePrimaryDNSaddressisrequiredinordertousethe
emailalertordynamicDNSfeatures.
 TheSecondaryDNSisoptional.Ifprovided,itisusedifthe
PrimaryDNSisunavailable.
Important
If you select to use DHCP, and no DHCP server is available, the camera defaults to IP
address 192.168.0.99. If your network does not support using this IP address, you
must set the camera to a supported fixed IP address before you can enable and
access the camera’s BlueScale Vision viewer.
If you select to use DHCP addressing, be aware that if the DHCP-assigned IP address
changes, you need to use the Network Configuration Wizard to find the new IP
address for the camera in order to access it.
Figure 238 Configure the TCP/IP settings for the camera.
IP Address Subnet Mask Default Gateway
10.10.10.11 255.255.255.0 10.10.10.1
Click arrow
to continue
Important
If you set the camera to use a fixed IP address, record that address for later
reference. If you do not know the camera’s IP address, you must reset the camera to
use DHCP addressing before you can connect to it. The reset process requires
physically accessing the camera. Contact Spectra Logic Technical Support for
assistance (see
Contacting Spectra Logic on page 7).