Spectra T950 - Page 418

Chapter 13 — Drive Troubleshooting Troubleshooting Drives
November 2016 User Guide—Spectra T950 Library
418
SCD Codes for LTO-2 Drives Ifmultipleerrorsoccur,thecodewithhighest
priority(lowestnumber)displaysfirst.Oncecorrected,thecodewiththe
nexthighestprioritydisplays,untilnoneremain.
Note: TheSCDisblankduringnormaloperation.
J IncompatibleMedia.
Thedrivedeterminedthatincompatiblemediawasloadedintothedrive.
P Thecartridgeinthedriveiswrite‐protected.Thestoragemanagementsoftware
cannotwritedatatoawrite‐protectedcartridge.Thelibrarycannotupdatethe
cartridgeMAMwhenthecartridgeiswrite‐protected.
u Firmwareupdateisinprogress.
b, c, H, h,
n, o
N/A Reservedornotactivelyinuse,ornoerrorormessageassigned.
TheremaybeaproblemwiththeSCD.Resetthedriveanddeterminewhether
allsegmentsontheSCDarelit.
 Iftheyarealllit,confirmthatthedriveisusingthecurrentfirmwareversion
(see
UpdatingDriveFirmwareonpage468)andupdatethefirmwareif
necessary.
 Iftheproblempersists,contactSpectraLogicTechnicalSupport(see
ContactingSpectraLogiconpage7).
… N/A Themessagedisplaylostcommunicationwiththedrive.Thismessageappears
onLine2ofthemessagedisplay.Thethreedotsmayoccasionallydisplayduring
normalprocessing.
Code DLM
Health
Icon
Cause and Solution
Code
DLM
Health
Icon
Cause and Solution
0 Noerroroccurred.Noactionisrequired.
Thepowerwascycledordiagnosticsfinishedwithnoerrors.
1 Coolingproblem.
Therecommendedoperatingtemperaturewasexceeded.Performoneormore
ofthefollowing:
 Ensurethatthecoolingfanisrotatingandisquiet.
 Removeanyblockagethatpreventsairfromflowingfreelythroughthetape
drive.
 Ensurethattheoperatingtemperatureandairflowiswithinthespecified
range.
 Iftheoperatingtemperatureiswithinthespecifiedrangeandtheproblem
persists,replacethedrive.
Note: Theerrorcodeclearswhenyouresetorpowercyclethetapedriveor
whenyouplaceitinmaintenancemode.