VM15 User Manual How to operate VM15
71
BEEP SIGNAL
Beep signal can select HR of ECG and PR of SpO2.
HR / PR is displayed depending on the selection.
Beep sound is synchronized to the selected parameter.
Note: If neither ECG nor SpO2 is measured : If the IBP is being measured, the beep
sound is synchronized to the IBP PR.
DEFAULTSET
In the Default set menu, you can select the patient category from Adult, Pediatric, or Neonate.
Depending on the selection, the default settings including alarms are changed.
Note: Table 9-4 shows the default alarm settings for each patient category.
PRINT SET
Set the function of print.
Refer to the '30. Printing (Option)' for details.
Note. Products without printer options, the menu is not activated.
DEMO
Operating mode can be set as demo mode.
In demo mode, you can test and learn how to operate
Note. In demo mode, the actual measured value is not displayed.
PATIENT INFO.
The monitor displays physiological data and stores the measured patient's data in a trend.
This allows the patient to be monitored.
Therefore, it is necessary to enter patient information so that the patient can be identified.
Enter the patient information: select each field and use the on-screen keyboard.
To Next Page
Loading...
