Weiler E2850 - Page 97

WEILER E2850 REMIXING TRANSFER VEHICLE
3-41
Operating Instructions
3
Paving
11. To stop machine movement, move Propel Lever (10)
to center/neutral position.
If Distance From Paver Control Engage/Disengage
Button is pressed or Propel Lever is centered to
disengage the system, the following message will
appear on the screen.
12. When the Distance From Paver Control System
automatically stops machine movement with the
system still active, the following message will appear
on the screen.
13. To maintain engagement of the Distance From
Paver Control System while system is in a “Time
Out” state, hold Distance From Paver Control
Engage/Disengage Button until machine moves.
Once transfer vehicle moves, the system is engaged
and the “Set Distance” will be maintained.
14. To disengage Distance From Paver Control System
while system is in a “Time Out” state, move Propel
Lever to center/neutral position or turn Park Brake
Switch (11) on.
10
! DISTANCE CONTROL
DISENGAGED !
ESC
! DISTANCE CONTROL
TIME OUT !
HOLD ENGAGE BUTTON
TO RESUME
ESC
11