YASKAWA GA700 - Control Circuit Wiring; Control Circuit Connection Diagram

2.14 Control Circuit Wiring
104 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
2.14 Control Circuit Wiring
This section gives information about wiring the control circuit.
◆ Control Circuit Connection Diagram
Wire the drive control circuit as shown in Figure 2.102.
Figure 2.102 Control Circuit Connection Diagram
*1 To operate the control circuit while the main circuit power supply is OFF, connect a 24 V power supply unit
(option).
*2 Install a wire jumper between terminals SC-SP-SN to select the type of the power supply for MFDI (sinking/
sourcing mode or internal/external power supply).
NOTICE: Do not close the circuit between terminals SP and SN. Failure to obey will cause damage to the drive.
• Sinking Mode: Install a jumper between terminals SC and SP.