3.6 Keypad Operation
166 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
2. Push (Menu).
3. Push or to select [Monitors], then push .
4. Push or to select [Trend Plot], then push .
The screen will show the monitors as shown in this figure.
Note:
Push (Hold) to switch between Pause and Restart for the monitor display. The “Hold (ENTER)” message flashes while monitoring
is paused.
◆ Change Parameter Settings
Do the steps in this procedure to set parameters for the application. This example shows how to change the setting
value for C1-01 [Acceleration Time 1].
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not on , push (Back).
2. Push (Menu).
To Next Page
Loading...
