10.5 b: Application
512 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
No.
(Hex.)
Name Description
Default
(Range)
Ref.
b8-20
(0B41)
Expert
E-Save Search
Width
Sets the amplitude of Energy-saving control search operations.
1.0 degrees
(0.1 - 5.0 degrees)
744
b8-21
(0B42)
Expert
PM E-Save Search
Gain
Sets the gain of Energy-saving control search operations.
0.3Hz
(0.1 - 20.0 Hz)
745
b8-22
(0B43)
Expert
PM E-Save Search
LPF Cutoff Freq
Sets the frequency of the filter used to extract the high-efficiency
phase from search operations. Usually it is not necessary to change
this setting.
10.0 Hz
(1.0 - 30.0 Hz)
745
b8-23
(0B44)
Expert
PM E-Save Search
Limit
Sets the search operations output limit. Usually it is not necessary to
change this setting.
15.0 degrees
(0.0 - 30.0 degrees)
745
b8-24
(0B45)
Expert
PM E-Save High
Freq ACR Gain
Sets the gain for high-frequency current control.
200.0 Hz
(100.0 - 1000.0
Hz)
745
b8-25
(0B46)
Expert
PM E-Save Search
Start Level
Sets the start level for search operations.
10.0%
(0.0 - 100.0%)
745
b8-26
(0B47)
Expert
PM E-Save Power
Setpoint
Sets a value to increase torque accuracy.
0.0%
(-10.0 - +10.0%)
745
b8-28
(0B8B)
Expert
Over Excitation
Action Selection
Sets the function for excitation operation.
0 : Disabled
1 : Enabled
0
(0, 1)
746
b8-29
(0B8C)
Energy Saving
Priority Selection
Sets the priority of drive response between changes to the load or
Energy-saving control.
0 : Priority: Drive Response
1 : Priority: Energy Savings
0
(0, 1)
746
b8-50
(0B0D)
Standby Mode
Selection
Sets the Standby Mode function.
0 : Disabled
1 : Enabled
0
(0, 1)
746
b8-51
(0B01)
Standby Mode
Wait Time
Sets the delay time before turning off the electromagnetic contactor
after the drive stops.
600 s
(0 - 6000 s)
747
◆ b9: Zero Servo
No.
(Hex.)
Name Description
Default
(Range)
Ref.
b9-01
(01DA)
Zero Servo Gain
Sets the responsiveness for the Zero Servo function.
5
(0 - 100)
747
b9-02
(01DB)
Zero Servo
Completion
Window
Sets the range to trigger an output terminal set for “Zero Servo
Complete” during Zero Servo operation. Be sure to set the deviation
from the Zero Servo start position.
10
(0 - 16383)
748
To Next Page
Loading...
