YASKAWA GA700 - Check Modified Parameters

Startup Procedure and Test Run
3
3.6 Keypad Operation
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 173
4. Push or to select the item to delete, then push .
5. Push or to select [Delete] , then push .
6. Push or to select the data to delete, then push .
The keypad will show the “End” message when the write process is complete.
◆ Check Modified Parameters
This procedure will show all parameters that were changed from their defaults as the result of Auto-Tuning or
setting changes. This helps find which settings have been changed, and is very useful when you replace a drive.
This lets users quickly access and re-edit changed parameters. If no parameters have been changed, the keypad
will show “0 Parameters”.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Modified Param / Fault Log], then prush .