YASKAWA GA700 - Attach the Protective Cover (Procedure B)

2.9 Change the Drive Enclosure Type
56 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
1. Remove the screws that attach the protective covers to the drive.
A - Screws that attach the protective cover
Figure 2.34 Remove the Screws that Attach the Protective Cover
2. Align the screw holes on conduit bracket 1 with the screw holes on the drive and push the bracket into
position. Use the screws to attach it.
A - Conduit bracket 1
B - Wiring holes
C - Screw holes
D - Screw hole
Figure 2.35 Attach Conduit Bracket 1
3. Align the screw holes on conduit bracket 2 with the screw holes on conduit bracket 1.
Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 lb.∙in. to 11.77 lb.∙in.).
A - Conduit bracket 2
Figure 2.36 Attach Conduit Bracket 2
4. Attach the front cover.
◆ Attach the Protective Cover (Procedure B)
■ Attach the Top Protective Cover
Align the hooks on the rear of top protective cover with the holes on the top of the drive to attach the top
protective cover.
Note:
• Attach the top protective cover and point the ( ) mark on the upper surface of the top protective cover away from the front of the
drive.
• Put the two small hooks on the rear of the top protective cover into the mounting holes near the back of the drive. Then push down on
the front side of the top protective cover to attach the cover.