Parameter List
10
10.5 b: Application
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 503
No.
(Hex.)
Name Description
Default
(Range)
Ref.
b1-14
(01C3)
Phase Order
Selection
Sets the phase order for output terminals U/T1, V/T2, and W/T3.
This parameter can align the Forward Run command from the drive
and the forward direction of the motor without changing wiring.
0 : Standard
1 : Switch Phase Order
0
(0, 1)
706
b1-15
(01C4)
Frequency
Reference
Selection 2
Sets the input method for frequency reference 2.
0 : Keypad
1 : Analog Input
2 : Memobus/Modbus Communications
3 : Option PCB
4 : Pulse Train Input
0
(0 - 4)
706
b1-16
(01C5)
Run Command
Selection 2
Sets the input method for Run Command 2 when the user switches
the control circuit terminals ON/OFF to change the Run command
source.
0 : Keypad
1 : Digital Input
2 : Memobus/Modbus Communications
3 : Option PCB
0
(0 - 3)
708
b1-17
(01C6)
Run Command at
Power Up
Sets drive response when energizing a drive that has an external Run
command. Set this parameter in applications where energizing or
de-energizing the drive enables the Run command.
0 : Disregard Existing RUN Command
1 : Accept Existing RUN Command
0
(0, 1)
709
b1-21
(0748)
Expert
CLV Start
Selection
Sets drive response to a Run command when A1-02 = 3 or 7
[Control Method Selection = Closed Loop Vector or PM Closed
Loop Vector]. Usually it is not necessary to change this setting.
0 : Reject RUN if b2-01<U1-05<E1-09
1 : Accept RUN Command at Any Speed
0
(0, 1)
709
b1-35
(1117)
Expert
Digital Input
Deadband Time
Sets the deadband time for MFDIs.
0.0 ms
(0.0 to 100.0 ms)
709
◆ b2: DC Injection Braking and Short Circuit Braking
No.
(Hex.)
Name Description
Default
(Range)
Ref.
b2-01
(0189)
DC Injection/Zero
SpeedThreshold
Sets the frequency to start DC Injection Braking, Short Circuit
Braking, and Zero Servo.
Note:
This parameter is available when b1-03 = 0 [Stopping Method
Selection = Ramp to Stop].
Determined by A1-
02
(0.0 - 10.0 Hz)
710
b2-02
(018A)
DC Injection
Braking Current
Sets the DC Injection Braking current as a percentage of the drive
rated current.
50%
(0 - 100%)
711
b2-03
(018B)
DC Inject Braking
Time at Start
Sets the DC Injection Braking Time at stop. Sets the zero speed
control at stop in CLV, AOLV, or CLV/PM.
A1-02 = 4: 0.03 s
Other than A1-02 =
4: 0.00 s
(0.00 - 10.00 s)
711
b2-04
(018C)
DC Inject Braking
Time at Stop
Sets the DC Injection Braking Time at stop. Sets the zero speed
control at stop in CLV, AOLV, or CLV/PM.
Determined by A1-
02
(0.00 - 10.00 s)
711
To Next Page
Loading...
