10.10 H: Terminal Functions
552 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
Setting Function Description Ref.
7D Short Circuit
Braking (N.C.)
Sets operation of Short Circuit Braking (N.C.).
ON : Normal operation
OFF : Short Circuit Braking is enabled.
Note:
When A1-02 = 8 [Control Method Selection = EZ Open Loop Vector Control], this
function is available if you use a PM motor.
885
7E Reverse Rotation
Identifier
Sets the rotation direction of the motor when in Simple Closed Loop V/f Control method
and F1-21, F1-37 = 0 [Encoder Option Function Selection = A pulse detection], or when
in Closed Loop V/f Control method.
ON : Reverse
OFF : Forward
886
7F PID Bi-Directional
Enable
Sets operation of the PID Bi-Directional function.
ON : Enabled
OFF : Disabled
886
90 to 97 DriveWorksEZ
Digital Inputs 1 to
8
Sets digital inputs used with DriveWorksEZ. Refer to the DriveWorksEZ Online Manual
for more information.
886
9F DWEZ Disable
Sets operation of the DriveWorksEZ program saved in the drive.
ON : Disabled
OFF : Enabled
Note:
Set A1-07 = 2 [DriveWorksEZ Function Selection = Digital input] to use this
function.
886
101 to 19F Inverse Input of 1
to 9F
Sets the function of the selected MFDI to operate inversely. To select the function, enter
“1xx”, where the “xx” is the function setting value.
Note:
You cannot use inverse input for all functions. Refer to Table 11.59 for more
information.
886
◆ H2: Digital Outputs
No.
(Hex.)
Name Description
Default
(Range)
Ref.
H2-01
(040B)
Term M1-M2
Function Selection
Sets the function for MFDO terminal M1-M2.
Note:
Set this parameter to F when the terminal is not being used or to
use the terminal in through mode.
0
(0 - 1A7)
889
H2-02
(040C)
Term M3-M4
Function Selection
Sets the function for MFDO terminal M3-M4.
Note:
Set this parameter to F when the terminal is not being used or to
use the terminal in through mode.
1
(0 - 1A7)
889
H2-03
(040D)
Term M5-M6
Function Selection
Sets the function for MFDO terminal M5-M6.
Note:
Set this parameter to F when the terminal is not being used or to
use the terminal in through mode.
2
(0 - 1A7)
889
To Next Page
Loading...
