YASKAWA GA700 - Save a Backup of Parameters

Startup Procedure and Test Run
3
3.6 Keypad Operation
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 169
7. Change the value, push .
The parameter setting procedure is complete.
◆ Save a Backup of Parameters
You can save a backup of the drive parameters to the keypad. The keypad can store parameter setting values for a
maximum of four drives in different storage areas. Making backups of the parameter settings can save time when
setting parameters after replacing a drive. If you set up more than one drive, you can copy the parameter settings
from a drive that completed a test run to the other drives.
Note:
• Always stop the motor before making a backup of the parameters.
• When making a backup, the drive will not accept Run commands.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .
4. Push or to select the items to back up, then push .
5. Push or to select [Backup (drive → keypad)], then push .