YASKAWA GA700 - Set the Keypad Language Display; Set the Date and Time

Startup Procedure and Test Run
3
3.6 Keypad Operation
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 179
◆ Set the Keypad Language Display
The procedure in this section shows how to set the language shown on the keypad.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back), to show [Home] on .
2. Push (Menu).
3. Push or to select [Initial Settings], then push .
4. Push or to select [Language Selection], then push .
5. Push or to select the language, then push .
The procedure to set the keypad language is complete.
◆ Set the Date and Time
The procedure in this section shows how to set the date and time.
Note:
• Refer to Replace the Keypad Battery on page 437 for information about the battery installation procedure.
To set the drive to detect an alarm when the battery is dead or when the clock is not set, install the battery then set o4-24 = 1 [bAT
Detection selection = Enable (Alarm Detected)].
• If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .