YASKAWA GA700 - Write Automatically Backed-Up Parameters to the Drive

Startup Procedure and Test Run
3
3.6 Keypad Operation
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 189
A - Drive Series
B - Maximum Applicable Motor
Output (HD/ND)
C - Rated Output Current (HD/ND)
D - Drive Software Version
E - Serial Number
◆ Write Automatically Backed-up Parameters to the Drive
You can automatically back up parameters to the keypad connected to the drive and write those parameters to a
different drive as specified by the settings of o3-06 [Auto Parameter Backup Selection] and o3-07 [Auto
Parameter Backup Interval].
Note:
• Set o3-06 = 1 [Auto Parameter Backup Selection = Enabled] in each drive to which you will write the parameters.
• This operation is not available when the parameters in the keypad and the parameters on the other drives are set to the same values.
1. Connect the keypad to the drive.
2. Push or to select [Yes] and then push .
3. Push or to select [Yes] and then push .
The keypad will show the “End” message when the write process is complete.