YASKAWA GA700 - Subchart A-3: EZ Open Loop Vector Control Test Run Procedure

3.4 Start-up Procedures
152 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
*1 For Yaskawa PM motors (SMRA-series, SSR1-series, or SST4-series), set E5-01 (Motor Code). For PM
motors from a different manufacturer, set E5-01 = FFFF.
*2 Be sure to release the holding brake before doing Inertia Tuning.
*3 In ASR Tuning, the drive will automatically tune Feed Forward control and KEB Ride-Thru 2 parameters.
◆ Subchart A-3: EZ Open Loop Vector Control Test Run Procedure
Subchart A-3 gives the setup procedure to run a PM motor in EZ Open Loop Vector Control.
Figure 3.11 Procedure for Test Run of EZ Open Loop Vector Control Method