Parameter List
10
10.9 F: Options
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 541
No.
(Hex.)
Name Description
Default
(Range)
Ref.
F6-64 to
F6-67
(03DF -
03E2)
Dynamic Out
Assembly 109
Param 1 to 4
Sets Configurable Outputs 1 to 4 written to the MEMOBUS register.
0000h
(0000h - FFFFh)
853
F6-68 to
F6-71
(03E3,
03E4, 03C7,
and 03C8)
Dynamic In
Assembly 159
Param 1 to 4
Sets Configurable Inputs 1 to 4 written to the MEMOBUS register.
0000h
(0000h - FFFFh)
853
F6-72
(081B)
PowerLink Node
Address
Sets the node ID for PowerLink communication.
Note:
Set a node address that is unique. Do not set this parameter to a
value of 0.
0
(0 - 255)
853
◆ F7: Ethernet Options
No.
(Hex.)
Name Description
Default
(Range)
Ref.
F7-01
(03E5)
IP Address 1
Sets the first octet of the IP Address for the device that is connecting
to the network. Restart the drive after you change this parameter.
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP
Address. Be sure to set a different IP address for each drive on
the network.
• Also set parameters F7-01 to F7-12.
192
(0 - 255)
854
F7-02
(03E6)
IP Address 2
Sets the second octet of the IP Address for the device that is
connecting to the network. Restart the drive after you change this
parameter.
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP
Address. Be sure to set a different IP address for each drive on
the network.
• Also set parameters F7-01 to F7-12.
168
(0 - 255)
854
F7-03
(03E7)
IP Address 3
Sets the third octet of the IP Address for the device that is
connecting to the network. Restart the drive after you change this
parameter.
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP
Address. Be sure to set a different IP address for each drive on
the network.
• Also set parameters F7-01 to F7-12.
1
(0 - 255)
854
F7-04
(03E8)
IP Address 4
Sets the fourth octet of the IP Address for the device that is
connecting to the network. Restart the drive after you change this
parameter.
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP
Address. Be sure to set a different IP address for each drive on
the network.
• Also set parameters F7-01 to F7-12.
20
(0 - 255)
854
F7-05
(03E9)
Subnet Mask 1
Sets the first octet of the subnet mask of the connected network.
Note:
Set this parameter when F7-13 = 0 [Address Mode at Startup =
Static].
255
(0 - 255)
854
To Next Page
Loading...
