11.7 F: Options
854 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
■ F7-01: IP Address 1
No.
(Hex.)
Name Description
Default
(Range)
F7-01
(03E5)
IP Address 1
Sets the first octet of the IP Address for the device that is connecting to the
network. Restart the drive after you change this parameter.
192
(0 - 255)
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP Address. Be sure to set a different IP address for each drive on the network.
• Also set parameters F7-01 to F7-12.
■ F7-02: IP Address 2
No.
(Hex.)
Name Description
Default
(Range)
F7-02
(03E6)
IP Address 2
Sets the second octet of the IP Address for the device that is connecting to
the network. Restart the drive after you change this parameter.
168
(0 - 255)
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP Address. Be sure to set a different IP address for each drive on the network.
• Also set parameters F7-01 to F7-12.
■ F7-03: IP Address 3
No.
(Hex.)
Name Description
Default
(Range)
F7-03
(03E7)
IP Address 3
Sets the third octet of the IP Address for the device that is connecting to the
network. Restart the drive after you change this parameter.
1
(0 - 255)
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP Address. Be sure to set a different IP address for each drive on the network.
• Also set parameters F7-01 to F7-12.
■ F7-04: IP Address 4
No.
(Hex.)
Name Description
Default
(Range)
F7-04
(03E8)
IP Address 4
Sets the fourth octet of the IP Address for the device that is connecting to
the network. Restart the drive after you change this parameter.
20
(0 - 255)
Note:
When F7-13 = 0 [Address Mode at Startup = Static]:
• Use parameters F7-01 to F7-04 [IP Address 4] to set the IP Address. Be sure to set a different IP address for each drive on the network.
• Also set parameters F7-01 to F7-12.
■ F7-05: Subnet Mask 1
No.
(Hex.)
Name Description
Default
(Range)
F7-05
(03E9)
Subnet Mask 1
Sets the first octet of the subnet mask of the connected network.
255
(0 - 255)
Note:
Set this parameter when F7-13 = 0 [Address Mode at Startup = Static].
To Next Page
Loading...
