YASKAWA GA700 - Delete Parameters Backed up to the Keypad

3.6 Keypad Operation
172 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
4. Push or to select the item to verify, then push .
5. Push or to select [Verify (check for mismatch)], then push .
6. Push or to select the data to verify, then push .
The keypad shows “End” when the parameter settings backed up in the keypad agree with the parameter settings
copied to the drive.
Note:
The keypad shows vFyE [Parameters do not Match] when the parameter settings backed up in the keypad do not agree with the
parameter settings copied to the drive. Push one of the keys to return to the screen in Step 6.
◆ Delete Parameters Backed Up to the Keypad
This procedure deletes the parameters that were backed up to the keypad.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .