3.6 Keypad Operation
164 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
10. Push to keep the changes.
11. Push or to select [Trend Plot 1 Scale Maximum Value], then push .
12. Push or to select the specified digit, then push or to select the correct number.
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
13. Push to keep the changes.
14. Push (Back).
If necessary, use the same procedure to set [Custom Monitor 2].
■ Set the Time Scale for the Trend Plot Monitor
The procedure in this section shows how to set the time scale for the trend plot monitor.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
To Next Page
Loading...
