YASKAWA GA700 - Page 182

3.6 Keypad Operation
182 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
4. Push or to select [Setup Wizard], then push .
5. Push or to select [Yes], then push .
Note:
This operation will initialize all parameters.
6. Push or to select the item to set, then push .
7. For the next steps, follow the instructions shown on the keypad until the “Parameter Change Confirmation
Screen” is shown.
8. In the parameter change confirmation screen, push or to examine the changed parameter, then
select [Apply of each parameter] at the bottom of the screen and push .
Note:
To change a parameter again, push or to select the parameter to change, then push to show the parameter
setting screen.
9. Push or to select [Yes], then push .
The Setup Wizard procedure is complete.