Standards Compliance
4
4.2 European Standards
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 229
The following conditions must be satisfied for machines and devices incorporating this product to comply with
the CE Low Voltage Directive.
■ Area of Use
Install this product in a location with overvoltage category III and pollution degree 2 or less. These standards are
defined by IEC/EN 60664.
■ Guarding against Debris
When installing IP20 enclosure drives (model: 2xxxB, 4xxxB), use an enclosure that does not let unwanted
material enter the drive from above or below.
■ Wiring Diagram
Refer to Figure 4.2 for an example of a drive that is wired to comply with the CE Low Voltage Directive.
To Next Page
Loading...
