10-36 IM 701450-01E
Selecting the Display Format of the Logic Input (When X-Y Waveforms Are Not
Displayed)
6. Press the Logic Setup soft key. The Logic Setup dialog box opens.
7. Use jog shuttle & SELECT to select the notation system.
8. Use jog shuttle & SELECT to select the read order of bit data.
9. Press ESC. The Logic Setup dialog box closes.
Select the notation system.
Select the read order of bit data.
Moving the Cursors
10. Press the Cursor1/Cursor2 soft key to set the jog shuttle control to Cursor1,
Cursor2, or both Cursor1 and Cursor2.
• Select Cursor1 to move Cursor1.
• Select Cursor2 to move Cursor2.
• If you select both Cursor1 and Cursor2, you can move Cursor1 and Cursor2
horizontally without changing the spacing between the two. The value of the digit being
specified by Cursor1 changes.
11. Turn the jog shuttle to move the cursor.
When X-Y waveforms
are not displayed
When X-Y waveforms
are displayed
Jumping the Cursor to the Zoom Waveform Display Frame (When X-Y Waveforms
Are Not Displayed)
12. Press the Cursor Jump soft key. The Cursor Jump menu appears.
13. Press the Cursor1 to Z1, Cursor1 to Z2, Cursor2 to Z1, or Cursor2 to Z2 soft
key to select the cursor and the jump destination.
14. Press the Jump Exec soft key. The cursor jumps to the specified zoom
waveform display frame.
10.5 Making Cursor Measurements
To Next Page
Loading...
