10-49
IM 701450-01E
10
Analyzing and Searching Waveforms
Setting Distal, Mesial, and Proximal Unit and Values
25. Press the Dist/Prox Mode soft key to select % or Unit.
• If you select %, you can set the distal, mesial, and proximal values in percentages by
taking the high level and low level of the waveform to be set to be 100% and 0%,
respectively.
• If you select Unit, you can set the distal, mesial, and proximal values in the range
corresponding to V/div×8 divisions within the screen.
26. Press the Distal soft key.
27. Turn the jog shuttle to set the distal value.
28. Press the Mesial soft key.
29. Turn the jog shuttle to set the mesial value.
30. Press the Proximal soft key.
31. Turn the jog shuttle to set the proximal value.
Setting the High and Low Values
32. Press the High/Low Mode soft key to select Auto or MAX-MIN.
• If you select Auto, the higher amplitude level is set to high and lower level is set to low
by taking into account the frequency of occurrence of the voltage level of the waveform
being measured within the measurement range and the effects of ringing and spikes.
• If you select MAX-MIN, the maximum value (MAX) and minimum value (MIN) within the
range are set to high and low values, respectively.
10.6 Automated Measurement of Waveform Parameters
To Next Page
Loading...
