Agilent Technologies 8960 Series Reference Guide

354
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_power.fm
CALL[:CELL]:POWer
CALL[:CELL]:POWer:STATe[:SELected]
Function Sets/queries the cell power state.
The optional [:SELected] keyword in this command specifies that the cell power state being set or
queried applies to the current system type. The current system type can be changed using the
“CALL[:CELL]:SYSTem[:TYPE]” command.
Cell power and AWGN (see “CALL:AWGNoise:POWer” ) are absolute power levels and make up
the total forward channel RF output power. Depending on the cell power setting, a cell power
level may be within the range listed below but cause an error message to be displayed. Possible
causes are:
• Sum of cell power and AWGN causing total RF power limits to be exceeded (see
“CALL:STATus:TOTal:POWer[:AMPLitude][:SELected]?” for the allowable range of total RF
power levels.)
• Greater than 10 dB difference between cell power and AWGN.
• Amplitude offset causing total RF power limits to be exceeded (see
“SYSTem:CORRection:GAIN” to set or query the amplitude offset value).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting ON
Programming Example
OUTPUT 714;"CALL:CELL:POWER:STATE OFF" !Turns off cell power.

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English