Agilent Technologies 8960 Series Reference Guide

737
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_ts_err_msg_pos100.fm
+100 through +199 Error Message Descriptions
+113 Internal error; <VI NAME> forced inactive Indicates that a VI is inactivated when not executed.
<VI NAME> includes : “IntVmVI”,”GprsBsEmulVI”,
“GsmComBsEmulVI”,“GSMFixedVI”, “MiscVI”,
“GSMSacchMriVI”, “IQSelfCalVI1”, “IQSelfCalVI2”,
“TA RevisionVI”, “TdmaTaBsEmulVI”.
+114 Internal error; <VI NAME> not responding Indicates that a VI has not been instantiated or the
state is not available.
<VI NAME> includes : “IntVmVI”,”GprsBsEmulVI”,
“GsmComBsEmulVI”, “GSMFixedVI”, “MiscVI”,
“GSMSacchMriVI”, “IQSelfCalVI1”, “IQSelfCalVI2”,
“TA RevisionVI”, “TdmaTaBsEmulVI” ,
“RfHwAccessVI”.
+115 Internal error; <VI NAME> inactive Indicates that a VI has been made inactive.
<VI NAME> includes : “IntVmVI”, “GSMFixedVI”,
“MiscVI”, “GSMSacchMriVI”, “IQSelfCalVI1”,
“IQSelfCalVI2”, “TA RevisionVI”.
+120 Warning; Receiver over range due to requested
settings
Indicates the total received power (a combination of
received power and amplitude offset) is above the
range of the test set.
+121 Warning; Receiver under range due to requested
settings
Indicates the total received power (a combination of
received power and amplitude offset) is below the
range of the test set.
+122 Warning; Reference out of lock Indicates the test set’s internal reference is out of lock.
+123 Warning; Duplicate RF IN/OUT Amplitude Offset
Frequency entry. First frequency entry in RF IN/OUT
Amplitude Offset table will be used.
Indicates that an amplitude offset value for that
frequency has already been entered. The test set will
use the amplitude offset value entered first.
+124 Warning; Source over range due to requested
settings
The setting selected for total transmit power (a
combination of cell power, awgn power, amplitude
offset) is above the test set’s range.
+125 Warning; Source under range due to requested
settings
The setting selected for total transmit power (a
combination of cell power, awgn power, amplitude
offset) is below the test set’s range.
+130 Configuration error; Unable to switch to indicated
Test Application
The test application selected is not available for this
test set.
+131 Configuration error; Current Test Application is
not licensed (License = N). Select another Test
Application
The test application selected is not licensed. Select
another revision or test application that is licensed
(License = L).
Error Message Description

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English