773
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_conf_lan.fm
Configuring the Test Set’s LAN
LAN Subnet Mask
The LAN subnet mask address is a character string with a maximum of 15 characters and a format of A, B, C,
D, where A , B, C, and D are between 0 and 255. No embedded spaces are allowed. The address may be
manually set/viewed in the system configuration screen. The LAN subnet mask address can be set/queried
using the SYSTem subsystem.
The subnet mask number combined with the IP address identifies which network and subnet your computer is
on. Contact your system administrator for the correct subnet mask for your network.
The subnet mask determines the boundaries between the subnet ID and the host ID.
The LAN subnet mask is a non-volatile parameter. The LAN subnet mask is not affected by any reset
operation and can only be changed by direct access to the parameter itself.
NOTE If the LAN address is set to a different network class, the subnet mask will change to the default
net mask for the new network class.
The subnet mask number is obtained from your network administrator.
Related Topics
“SYSTem:COMMunicate”
To Next Page
Loading...
Need help?
General
