Allied Telesis AT-9000/28 - Show Rmon Event; Table 105. SHOW RMON EVENT Command

AT-9000 Switch Command Line User’s Guide
Section X: Network Management 1015
SHOW RMON EVENT
Syntax
show rmon event
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display the RMON events on the switch. Here is an
example of the information.
Figure 165. SHOW RMON EVENT Command
The fields are described in Table 105.
Event index = 2
Description: broadcast_packets
Event type: log & trap
Event community name: wkst12a
Last Time Sent = 0
Owner: Agent
Event index = 3
Description: port24_traffic
Event type: log
Event community name:
Last Time Sent = 0
Owner: Wilson
Table 105. SHOW RMON EVENT Command
Parameter Description
Event index The ID number of the event.
Description The description of the event.
Event type The event type. The types are:
 Log - The event enters a message in
the event log.
 Trap - The event sends an SNMP
trap.