AT-9000 Switch Command Line User’s Guide
Section XI: Management Security 1179
CRYPTO CERTIFICATE IMPORT
Syntax
crypto certificate
id_number
import
Parameters
id_number Specifies the ID number of a certificate to be imported
into the certificate database on the switch. You can
specify just one ID number.
Mode
Global Configuration mode
Description
Use this command to import certificates from public or private CAs into the
certificate database of the switch. A certificate has to be residing in the file
system on the switch before you can import it into the certificate database.
Entering the WRITE or COPY RUNNING-CONFIG STARTUP-CONFIG
command after importing a certificate is unnecessary because certificates
are not stored in the active boot configuration file.
Confirmation Command
“SHOW IP HTTPS” on page 1186
Example
This example imports a certificate with the ID number 2 into the
certification database from the file system:
awplus> enable
awplus# configure terminal
awplus(config)# crypto certificate 2 import
To Next Page
Loading...
