AT-9000 Switch Command Line User’s Guide
Section VIII: Port Security 775
NO AUTH-MAC ENABLE
Syntax
no auth-mac enable
Parameters
None.
Mode
Port Interface mode
Description
Use this command to deactivate MAC address-based authentication on
authenticator ports. The ports continue to function as authenticator ports,
but authentication is based on the usernames and passwords provided by
the supplicants and not on the MAC addresses of the nodes. To
completely remove authentication from ports, refer to “NO DOT1X PORT-
CONTROL” on page 776.
Confirmation Command
“SHOW DOT1X SUPPLICANT INTERFACE” on page 785
Example
This example removes MAC address-based authentication from port 23:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23
awplus(config-if)# no auth-mac enable
To Next Page
Loading...
