Allied Telesis AT-9000/28 - No Lldp Tlv-Select

AT-9000 Switch Command Line User’s Guide
Section X: Network Management 945
NO LLDP TLV-SELECT
Syntax
no lldp tlv-select all| tlv
Parameters
all Removes all optional LLDP TLVs from a port.
tlv Removes an optional TLV from a port. You can
specify just one TLV. To remove more than one TLV
from a port, repeat the command as many times as
needed.
Mode
Port Interface mode
Description
Use this command to stop ports from sending optional LLDP TLVs to their
neighbors. The optional TLVs are listed in Table 90 on page 928.
To stop ports from transmitting LLDP-MED TLVs, refer to “NO LLDP MED-
TLV-SELECT” on page 941.
Confirmation Command
“SHOW LLDP INTERFACE” on page 951
Example
This example configures ports 21 and 22 to stop transmitting all optional
LLDP TLVs:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21,port1.0.22
awplus(config-if)# no lldp tlv-select all
This example stops the transmission of the management-address and
system-capabilities TLVs on port 11:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11
awplus(config-if)# no lldp tlv-select management-address
awplus(config-if)# no lldp tlv-select system-capabilities