Allied Telesis AT-9000/28 - Lldp Holdtime-Multiplier

Chapter 62: LLDP and LLDP-MED Commands
914 Section X: Network Management
LLDP HOLDTIME-MULTIPLIER
Syntax
lldp holdtime-multiplier value
Parameters
value Specifies the holdtime multiplier value. The range is 2
to 10.
Mode
Global Configuration mode
Description
Use this command to set the holdtime multiplier value. The transmit
interval is multiplied by the holdtime multiplier to give the Time To Live
(TTL) the switch advertises to the neighbors. The transmit interval is set
with “LLDP TIMER” on page 927.
Confirmation Command
“SHOW LLDP” on page 949.
Example
This example sets the holdtime multiplier to 7:
awplus> enable
awplus# configure terminal
awplus(config)# lldp holdtime-multiplier 7