AT-9000 Switch Command Line User’s Guide
Section XI: Management Security 1137
Disabling the SSH Server
If you decide that you want to disable the server because you do not want
to remotely manage the switch with SSH, enter the following commands:
awplus> enable
awplus# configure terminal
awplus(config)# no ssh service
Note
If you disable the server during a remote SSH management session,
your session ends. To resume managing the unit with the same
management account, you must wait for the console timer on the
switch to expire and then establish a local management session or
remote Telnet or web browser session.
To Next Page
Loading...
