AT-9000 Switch Command Line User’s Guide
Section X: Network Management 939
LOCATION ELIN-LOCATION
Syntax
location elin-location
elin_id
identifier
id_number
Parameters
elin_id Specifies the ELIN (Emergency Location
Identification Number) of 10 to 25 digits.
id_number Specifies an ID number for a LLDP-MED coordinate
location entry on the switch. The range is 1 to 256.
(This range is separate from the ranges for civic and
coordinate entries.) You can specify just one ID
number.
Mode
Global Configuration mode
Description
Use this command to create or modify LLDP-MED ELIN location entries on
the switch. To create a new ELIN TLV, specify an unused ID number. To
modify an existing ELIN TLV, enter its ID number.
To assign ELIN location entries to ports on the switch, use “LLDP
LOCATION” on page 915.
Confirmation Command
“SHOW LOCATION” on page 965
Examples
This example creates a new location entry for ELIN 1234567890, with the
ID number 15:
awplus> enable
awplus# configure terminal
awplus(config)# location elin-location 1234567890 identifier
15
To Next Page
Loading...
