Chapter 38: STP Commands
508 Section VI: Spanning Tree Protocols
SPANNING-TREE STP ENABLE
Syntax
spanning-tree stp enable
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to enable STP on the switch. You must designate STP
as the active spanning tree protocol on the switch before you can enable it
or configure its parameters. For instructions, refer to “SPANNING-TREE
MODE STP” on page 502.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 129 or “SHOW SPANNING-TREE”
on page 498
Example
This example enables STP on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree stp enable
To Next Page
Loading...
