Allied Telesis AT-9000/28 - SPANNING-TREE PRIORITY (Port Priority); Table 58. Port Priority Value Increments

AT-9000 Switch Command Line User’s Guide
Section VI: Spanning Tree Protocols 549
SPANNING-TREE PRIORITY (Port Priority)
Syntax
spanning-tree priority priority
Parameters
priority Specifies the priority value for a port. The range is 0 to
240, in increments of 16.
Mode
Port Interface mode
Description
Use this command to set the priority values of the ports. This parameter is
used as a tie breaker when two or more ports have equal costs to the root
bridge. The range is 0 to 240 in increments of 16, for a total of 16
increments. The increments are shown in Table 58. You specify in the
command the increment of the value you want to assign a port. The default
is 128, which is increment 8.
Confirmation Command
“SHOW SPANNING-TREE” on page 533
Table 58. Port Priority Value Increments
Increment
Port
Priority
Increment
Port
Priority
008128
1 16 9 144
2 3210160
3 48 11 176
4 6412192
5 8013208
6 9614224
7 112 15 240