AT-9000 Switch Command Line User’s Guide
Section X: Network Management 913
CLEAR LLDP TABLE
Syntax
clear lldp table [interface
port
]
Parameters
port Specifies a port. You can specify more than one port
at a time in this command. Omitting this parameter.
specifies all the ports.
Mode
Privileged Exec mode
Description
Use this command to clear the LLDP and LLDP-MED information the
switch has received from its neighbors. You can delete all the information
the switch has amassed or just the information from neighbors on selected
ports.
Example
This example clears the information the switch has received from all
neighbors:
awplus> enable
awplus# clear lldp table
This example clears the information the switch has received from the
neighbors connected to ports 6 and 8:
awplus> enable
awplus# clear lldp table interface port1.0.6,port1.0.8
To Next Page
Loading...
